Open Access Open Access  Restricted Access Subscription or Fee Access

An Efficient Nano Sensor for Strain Sensing and Defect Detection in Engineering Components

N Marie Claude, Dr.N. Marie Wilson, Dr.V. Kannan

Abstract


This work demonstrates the application of PVDF/CNT composite as strain sensor and defect detector. The PVDF/CNT films were prepared by solution/filtration method and were bonded directly onto specimens by nonconductive adhesive. The two electrodes were connected on to PVDF/CNT films with silver conducting epoxy to reduce contact resistance. Conventional Strain gauge is also attached to other end of the specimen for comparison. For testing purpose 9CR 1MO material is considered and cut into dog bone shaped structures according to ASTM standards. Tensile load is applied by subjecting the specimen in a servo hydraulic test frame .Calibration curves were plotted with change in voltage versus the strain obtained in test specimen. The result shows that there is linear change in voltage across the film when subjected to tension. The defect detection is done using electronic measurement technique. The results shows that the presence of defect was marked by high value of resistance on that particular region and the resistance value was low in non-defective region.


Keywords


Carbon Nanotubes (CNT), Polyvinylidenefluoride (PVDF), Composite Films, Strain Sensor, Defect Detection.

Full Text:

PDF

References


Ayoola Ike Akinwande Jr. ,Nanocomposite Strain Sensors: Study of Electrical and Thermal Properties, Rice University, UMI Number:1441794

Iijima, S. Helical microtubules of graphitic carbon. Nature, 1991, 354(6348), 56–58.

Schadler, L. S., Giannaris, S. C., and Ajayan, P. M., Load transfer in carbon nanotube epoxy composites. Appl. Phys. Lett., 1998, 73(26), 3842–3844.

Li, Z., Dharap, P., Sharma, P., Nagarajaiah, S., and Yakobson, B. I., Continuum field model of defect formation in carbon nanotubes, J. Appl. Phys.,2005, 97(7), 074303-8.

P.Kumar Raj, T. Saravanan, Vaidehi Ganesan and Krishnan Balasubramaniam “Detection of microcracks in the HP turbine blades using Phased array and Radiography techniques and enhancement of radiographic images by image proceesing” NDE-Dec 2009, BHEL, Trichy

J. C. Rauhe, L. R. Jensen and R. Pyrz ,Strain Sensing in Carbon Fibre Reinforced Materials using Electromechanical measurements, Department of Mechanical Engineering, Aalborg University Pontoppidanstraede 101, DK-9220 Aalborg East, Denmark

Vaidehi Ganesan, “Studies on Nuclear materials and engineering components-weld related failures” Lead lecture presented during International Symposium on Joining of Materials (SOJOM 2008), Dec 11-13.

K. J. Loh, J. P. Lynch, And N.A. Kotov , Nanoengineered Inductively Coupled Carbon Nanotube Wireless Strain Sensor , 4th World Conference On Structural Control And Monitoring

Jun Zhou, Yudong Gu, Peng Fei, Wenjie Mai, Yifan Gao, Rusen Yang, Gang Bao , and Zhong Lin Wang, Flexible Piezotronic Strain Sensor,Nano Letters, NANO LETTERS 2008,Vol. 8, No. 9

L.-M. Peng, Z. L. Zhang, Z. Q. Xue, Q. D. Wu, Z. N. Gu, and D. G. Pettifor, Stability of Carbon Nanotubes: How Small Can They Be?, Phys. ReV. Lett. 2000, 85, 3249.

Jing Zhao, Congli He, Rong Yang, Zhiwen Shi, Meng Cheng, Ultra-sensitive strain sensors based on piezoresistive nanographene films, APPLIED PHYSICS LETTERS 101, (2012)

Chao-Xuan Liu, and Jin-Woo Choi,An Embedded PDMS Nanocomposite Strain Sensor toward Biomedical Applications, 31st Annual International Conference of the IEEE EMBS Minneapolis, Minnesota, USA, September 2-6, 2009

Kapova, I.ap, L. Janousek, M. Smetana, Recent Trends In Electromagnetic Non-Destructive Sensing, Journal of Advances in Electrical and Electronic Engineering,pp322-325.

Byoung Chul Kim , Young Gun Heo , Yong Kweon Suh and Young Han Kim ,Detection of Simulated Defect Using IR Temperature Sensors and One Point Heating, Open Access Sensors 2008, 8,pp 3345-3354

Pedro Navarro, Andres Iborra , Carlos Fernández, Pedro Sánchez and Juan Suardíaz, A Sensor System for Detection of Hull Surface Defects, Open Access Sensors 2010, 10, 7067-7081

Marwan Al-Haik, Claudia Luhrs, Zayd Leseman, and Mahmoud Reda Taha, Introducing Nanotechnology to Mechanical and Civil Engineering Students Through Materials Science Courses, Journal of Nano Education, Vol. 2, 13–26, 2010


Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.