Open Access Open Access  Restricted Access Subscription or Fee Access

Closed Loop Control of Interleaved High Step up Converter for Sustainable Energy Applications

Maria T Kuriyakose, Aswathy Rajan

Abstract


The grid-connected systems employing Photovoltaic and fuel cells call for high step- up dc/dc topologies. Large voltage conversion ratio with ten times voltage gain is mandatory for the front-end dc/dc converters. In this paper, the built-in transformer multiplier cell is inserted into each phase of the conventional interleaved boost converter. The voltage multiplier cell is composed by the built-in transformer windings, diodes and capacitors. Additional active switches are not required to simplify the circuit configuration. Moreover, the switch voltage stress and the diode peak current are also minimized and reverse recovery problem of the diodes can be minimised. In addition, the switch turn-off voltage spikes are suppressed effectively by zero current switch (ZCS) turn-on across the switches, which can enhance the reliability. To study the performance of the high step up Interleaved boost converter with closed loop, simulations has been carried out in MATLAB 2013 environment. The waveforms agreed with the operating principles and the steady-state analysis.


Keywords


Interleaved Boost Converter, Interleaved Converter, Built In Transformer Voltage Multiplier Cell, Regenerative Diode, Soft Switching (ZCS).

Full Text:

PDF

References


Y.Gu, W. Li, Y. Zhao, B.Yang, C. Li, and X. He, “Transformerless inverter with virtual DC bus concept for cost-effective grid-connected PV power systems,” IEEE Trans. Power Electron., vol. 28, no. 2, pp. 793–805, Feb. 2013.

G. Spiazzi, P. Mattavelli, and A. Costabeber, “High step-up ratio flyback converter with active clamp and voltage multiplier,” IEEE Trans. Power Electron., vol. 26, no. 11, pp. 3205–3214, Nov. 2011.

W. Li, L. Fan, Y. Zhao, X. He, D. Xu, and B.Wu, “High step-up and high efficiency fuel cell power generation system with active clamp flybackforward converter,” IEEE Trans. Ind. Electron., vol. 59, no. 1, pp. 599–610, Jan. 2012.

Y. Zhao, X. Xiang, W. Li, X. He, and C. Xia, “Advanced symmetrical voltage quadrupler rectifiers for high step-up and high output-voltage converters,” IEEE Trans. Power Electron., vol. 28, no. 4, pp. 1622–1631, 2013.

W. Li and X. He, “Review of non-isolated high step-up DC/DC converters in photovoltaic grid-connected applications,” IEEE Trans. Ind. Electron., vol. 58, no. 4, pp. 1239–1250, 2011.

H.Wu and X. He, “Single phase three-level power factor correction circuit with passive lossless snubber,” IEEE Trans. Power Electron., vol. 17, no. 6, pp. 946–953, Nov. 2002.

L. huber and M. M. Jovanovic, “A design approach for server power supplies for networking,” in Proc. IEEE INTELEC’00, 2000, pp. 1163– 1169.

M. Prudente, L. L. Pfitscher, G. Emmendoerfer, E. F. Romaneli, and R. Gules, “Voltage multiplier cells applied to non-isolated DC–DC converters,” IEEE Trans. Power Electron., vol. 23, no. 2, pp. 871–887, Mar. 2008.

F. Zhang, L. Du, F. Z. Peng, and Z. Qian, “A new design method for high-power high-efficiency switched-capacitorDC–DC converters,” IEEE Trans. Power Electron., vol. 23, no. 2, pp. 832–840, Mar. 2008.

B. Axelrod, Y. Berkovich, and A. Ioinovici, “Switchedcapacitor/ switched-inductor structures for getting transformerless hybrid DC–DC PWM converters,” IEEE Trans. Circuits Syst. I, Reg. Papers, vol. 55, no. 2, pp. 687–696, Mar. 2008.

E. H. Ismail, M. A. Al-Saffar, A. J. Sabzali, and A. A. Fardoun, “A family of single-switch PWM converters with high step-up conversion ratio,” IEEE Trans. Circuits Syst. I, Reg. Papers, vol. 55, no. 4, pp. 1159–1171, May 2008.

K. B. Park, G. W.Moon, andM. J. Youn, “Nonisolated high step-up boost converter integrated with sepic converter,” IEEE Trans. Power Electron., vol. 25, no. 9, pp. 2266–2275, Sep. 2010.

K. C. Tseng and T. J. Liang, “Novel high-efficiency step-up converter,” in Proc. IEE-Elect. Power Appl., vol. 151, no. 2, Mar. 2004, pp. 182–190.

Y. Zhao, W. Li, and X. He, “Single-phase improved active clamp coupledinductor- based converter with extended voltage doubler cell,” IEEE Trans. Power Electron., vol. 27, no. 6, pp. 2869–2878, Jun. 2012.

L. S. Yang, T. J. Liang, H. C. Lee, and J. F. Chen, “Novel high step-up DC–DC converter with coupled-inductor and voltage-doubler circuits,” IEEE Trans. Ind. Electron., vol. 58, no. 9, pp. 4196–4206, Sep. 2011.

K. B. Park, G. W. Moon, and M. J. Youn, “High step-up boost converter integrated with a transformer-assisted auxiliary circuit employing quasi-resonant operation,” IEEE Trans. Power Electron., vol. 27, no. 4, pp. 1974–1984, Apr. 2012.

S. V. Araujo, R. P. Torrico-Bascope, and J. V. Torrico-Bascope, “Highly efficient high step-up converter for fuel-cell power processing based on three-state commutation cell,” IEEE Trans. Ind. Electron., vol. 57, no. 6, pp. 1987–1997, Jun. 2010.

G. A. L. Henn, R. N. A. Silva, P. P. Praca, L. H. S. Barreto, and D. S. Oliveira, “Interleaved-boost converter with high voltage gain,” IEEE Trans. Power Electron., vol. 25, no. 11, pp. 2753–2761, Jan. 2010.

W. Li and X. He, “A family of interleaved DC/DC converters deduced from a basic cell with winding-cross-coupled inductors (WCCIs) for high step-up or step-down conversions,” IEEE Trans. Power Electron., vol. 22, no. 4, pp. 1499–1507, Jul. 2008.

W. Li, Y. Zhao, J. Wu, and X. He, “Interleaved high step-up converter with winding-cross-coupled inductors and voltage multiplier cells,” IEEE Trans. Power Electron., vol. 27, no. 1, pp. 133–143, Jan. 2012.

K. B. Park, G. W. Moon, and M. J. Youn, “Nonisolated high step-up stacked converter based on boost-integrated isolated converter,” IEEE Trans. Power Electron., vol. 26, no. 2, pp. 577–587, Feb. 2011.

W. Li, W. Li, X. He, D. Xu, and B. Wu, “General derivation law of nonisolated high step-up interleaved converters with built-in transformer,” IEEE Trans. Ind. Electron., vol. 59, no. 3, pp. 1650–1661, Mar. 2012.

H.-L. Do, “Asoft-switching dc/dc converter with high voltage gain,” IEEE Trans. Power Electron., vol. 25, no. 5, pp. 1193–1200, May. 2010.

Y. Deng, Q. Rong, W. Li, Y. Zhao, J. Shi, and X. He, “Single switch high step-up converters with built-in transformer voltage multiplier cell,” IEEE Trans. Power Electron., vol. 27, no. 8, pp. 3557–3567, Aug. 2012.

W. Li, X. Xiang, C. Li, W. Li, and X. He, “Interleaved high step-up ZVT converter with built-in transformer voltage doubler cell for distributed PV generation system,” IEEE Trans. Power Electron., vol. 28, no. 1, pp. 300– 313, Jan. 2013.


Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.