Email this article 
Open Access
Subscription or Fee Access
Closed Loop Control of Soft Switched Single Switch Isolated Step Up DC-DC Converter
Abstract
The high switching frequencies in power converters increases the switching losses, and electromagnetic interferences. These losses can be overcome by employing soft switching techniques. The paper introduces a soft switched single switch isolated DC-DC Converter where Switching losses, current and voltage stress can be reduced. The presented converter can be Zero current Switching (ZCS) turn on and Zero-Voltage Switching (ZVS) turn off of diodes and switches, regardless of load variation. The simulation of the circuit with 12V input, 100V/0.1A output is validated using MATLAB.
Keywords
References
Q.Li and P.Wolfs, “A review of the single phase photovoltaic module integrated converter topologies with three different dc link configurations” IEEE trans. Power Electron. Vol. 23,no 3, pp 1320-1333, May 2008
N.D Benavides and P.L Chapman, “Mass –optimal design methodology for DC-DC Converters in low –power portable fuel cell applications.” IEEE, Trans power Electron, Vol 23, no 3, pp 1545-1555, May 2008
C.D Davidson, “Zero Voltage switching isolated boost converter topology “, in proc, IEEE 33rd Int.Telecomm.Energy conf. Oct 2011, pp1-8.
D A Ruiz Caballero and I. Barbi ,” A new flyback current fed push pull DC-DC Converter ,” IEEE trans.Power Electron,Vol 14, no.6,pp 1056-1064, Nov 1999.
H. Ma, L.Chen and Z.Bai ,” An active – clamping current fed push pull converter for vehicle inverter application and resonance analysis ,” in proc. IEEE Int sym.Ind .Electron, 2012, pp160-165
V. Yakushev, V. Meleshin and S. Fraidlin, “Full –bridge isolated current fed converter with active clamp.” In proc.IEEE Appl. Power Electron.conf.Expo, vol 1,1999, pp 1948-1954
J.-H.lee,J-H .Park, and J-H Jean,” Series-connected forward- flyback converter for high step up power conversion.” IEEE Trans. Power Electron, Vol 26, no-12 ,pp 3629-3641,Dec 2011
F.J Nome and I Barbi, “A ZVS clamping mode current fed push pull DC-DC converter “ in proc. IEEE int symp.ind.Electron,vol.2,1998, pp .617-621.
S. Han, H. Yoon, G.Moon, M.Youn, Y.Kim and K.Lee, “ A new active clamping Zero –volatge switching PWM current fed half bridge converter”, IEEE, Trans, Power Electron ,Vol 20,no-6,pp 1271-1279,Nov 2005.
Haci Bodur and A. Faruk Bakson “A new ZVT-ZCT PWM DC-DC Converter” IEEE Trans. Power Electron. Vol 19, no.3,May 2004
J. H. Lee, T. J. Liang, and J. F. Chen, “Isolated coupled-inductor-integrated DC-DC converter with nondissipative snubber for solar energy applications,” IEEE Trans. Ind. Electron., vol. 61, no. 7, pp. 3337–3348, Jul. 2014..
C.-W. Roh, C.-H. Yoo, D.-Y. Jung, and S.-C. Sakong, “Polarity inversion DC–DC power conversion circuit with high voltage step-up ratio,” J. Power Electron., vol. 11, no. 5, pp. 669–676, Sep. 2011
J. Kwon and B. Kwon, “High step-up active-clamp converter with inputcurrent doubler and output-voltage doubler for fuel cell power systems,” IEEE Trans. Power Electron., vol. 1, no. 1 , pp. 108–115, Jan. 2009.
J.-M. Kwon,W.-Y. Choi, and B.-H. Kwon, “Single-switch quasi-resonant converter,” IEEE Trans. Ind. Electron., vol. 56, no. 4, pp. 1158–1163, Apr. 2009
T. J. Liang, R. Y. Chen, and J. F. Chen, “Current-fed parallel-resonant dc– ac inverter for cold-cathode fluorescent lamps with zero-current switching,” IEEE Trans. Power Electron., vol. 23, no. 4, pp. 2206–2210, Jul. 2008.
Minjae Kim, Student Member, IEEE, and Sewan Choi, Senior Member, “A Fully Soft-Switched Single Switch Isolated DC–DC Converter” IEEE transactions on power electronics, vol. 30, no. 9, September 2015.
DOI: http://dx.doi.org/10.36039/AA092016003.
Refbacks
- There are currently no refbacks.
This work is licensed under a Creative Commons Attribution 3.0 License.